- Model NO.: sp-751
- Usage: for Anilox Roll
- Trademark: sp-751
- Certification: SGS
- Category: Cleaner
Japan three-color anilox roll cleaner, its characteristic is easy to use, the effect is remarkable, do not need any auxiliary Settings, in a short time can hole of printing ink, light net oil and paint layer remove, restore cure for a clean ceramic anilox roll, maintain its original preach ink, coating effect.
Manufacturer: three-color chemical corporation
Capacity: 20 kg
Dry joint (used for gluing of paint, commonly called the GRAVURE roller flexo (your). In the daily operation, should be cleaned together after the glue slot and circulating pump (but 24 hours of homework except). But with acetic acid to do cleaning, will then agent completely clean is a very difficult task. The traces of the agents will still remains on rubber wheel in, so repeated stack will cause the sedimentation of the plug, and plug in the mesh of version in the agents once sclerosis, then can't dissolve in acetic acid, not to mention how the effect of cleaning.
And so plug on state version in the operations, rubber wheel will cause of coating is enough of problems, such as bad appearance (there will be produced) and then bubble agent strength and the quality problems, and bad reasons of the occurrence mostly due to use plug version of the roller is caused by the problem of insufficient where cloth. In order to prevent this problem, should take place continuously to wash in liquid version (NEO REVER) to wash roller to getting the right amount of coating.
In this we use wash version of the liquid and steps of the article matters of attention as follows:
1. The first by acetic acid cleaning glue and rubber wheel on the sheet.
2. In the glue sink on the shop 3-4 zhang film. (OPP, PET, CPP, LLDPE all but)
3. Start, at the same time on idling roller washing liquid rubber roll with full version, and placed a 5-10 minutes, (hardening of the glue will be quickly to the surface of the round adsorption).
4) to brush the mesh of metal rubber wheel brush, vertical force and 2-3 times overall cleaning.
5. If there is a net wash not deep version of the place, and once again in metal continue to clean.
6. With 2-3 kg of acetic acid, side brush with metal dumping acetic acid to tire, rubber wheel will remain on to the washing liquid rushed down version.
7. Will blunt fall into the groove liquid and then wash version with a piece of film agent scraps take away.
8. In the slot into 10 kilograms of acetic acid, and make rubber wheel on contact with conditions, a rubber wheel, a metal idling brush or clean cloth to wipe clean, has been to try in foreign body wash version so far.
9. Repeat the above 8, 9 o 'clock homework assignments programs, which is to prevent liquid residue. Wash edition
10. To 3-5 liters of acetic acid rain poured again, and again with dishcloth rubber wheel polishing the try rubber wheel.
11. With clean dry cloth to wipe rubber wheel to again.
12. Will the groove acetic acid and the film substrate is complete the work. Take away
Cleaning time 30 minutes. Once a week or two weekly with wash clean liquid version of rubber wheel is very necessary. (and frequency of cleaning, it depends on the situation of the daily maintenance and decide, if often in acetic acid to cleaning and maintenance is two times on Monday to wash to cleaning liquid version to clean clean can. Also it depends on the quantity and the coating appearance condition to decide).